DUMP TRAILER Electrical power UNIT-DOUBLE ACTING
This power unit features a energy up power down circuit with load holding on the two A & B ports. A pressure compensatred movement management could be extra to circuit to control the decent speed in the cylinder.
one. This power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean each of the hydraulic parts concerned before installation of the electrical power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst, which should also be clean and free of impurities. N46 hydraulic oil is advisable.
four. The power unit must be mounted horizontally.
five. Check the oil degree from the tank following the preliminary operating in the energy unit.
six. Oil changing is required immediately after the initial 100 operation hours, afterwards when each and every 3000 hours.
DUMP TRAILER Electrical power UNIT- SINGLE ACTING
This electrical power unit features a power up gravity down circuit. Commence the motor to lengthen the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve could be offered if essential. Also a pressure compen sated movement control can be additional on the circuit to manage the descent pace of your cylinder.
Remark: Please seek advice from our income engineer for your unique pump displacement, motor power or tank capacity.
one. This energy unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean every one of the hydraulic parts concerned ahead of set up of the power unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is advised.
4. The electrical power unit need to be mounted horizontally.
five. Check the oil degree in the tank following the original operating on the energy unit.
6. Oil modifying is required right after the first a hundred operation hours, afterwards as soon as every single 3000 hours.