Power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE one
Basic Description
This energy unit is made solely for your little lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit continues to be extensively utilised inside the field of logistic gadgets such as minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled through the solenoid valve with all the pace managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Common Description
This power unit is made exclusively for your medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve as well as the velocity managed from the adjustable needle valve. When the lift rises to a substantial positoin, however the power provide is cut, the lowering movement is controlled from the guide override function.
Power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is built exclusively to the large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as velocity managed by a strain compensated movement manage valve.
Energy UNITS FOR LIFT TABLE 4
Common Description
This energy unit is intended solely for that substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve plus the velocity controlled through the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is minimize, the reducing movement is managed from the manual override perform.
Specific Notes
one. This energy unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned before installation of the electrical power unit.
3. Viscosity from the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is encouraged.
four. Oil modifying is required right after the original a hundred operation hours,afterwards as soon as just about every 3000 hours.
5. The energy unit shown is built to be mounted vertically.

Tags

flexible jaw coupling

As one of leading flexible jaw coupling manufacturers, suppliers and exporters of products, We offer flexible jaw coupling and many other products.

Please contact us for details.

Mail:[email protected]

Manufacturer supplier exporter of flexible jaw coupling

Recent Posts