Material Handling Electrical power UNIT one
This electrical power unit is intended for that fork lift business, consisting of very effective gear pump, DC motor, manual raise and reduce valve, tank, ect. The up and down motion are managed through the lever on the manual release valve, which can be equipped with an electrical switch to activate the motor. The lowing pace is managed by the stress compensated movement management valve.
one. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean the many hydraulic parts concerned prior to set up of the power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of impurities, N46 hydraulic oil is advisable .
four. Oil shifting is required immediately after the initial a hundred operation hours, afterwards once every 3000 hours.
five. The electrical power unit shown is designed to be mounted horizontally.
Material Handling Power UNIT 2
This power unit capabilities power up gravity down circuit. Activate the start off solenoid to start out the motor to lift the machine. The lowing motion is activated through the solenoid valve together with the lowering velocity managed through the pressure compensated movement handle valve. Solutions of this series may be extensively utilized in the field of logistic units like fork lift, mini lift table, and so on.
1. The duty of this energy unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean all of the hydraulic elements concerned before mounting the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which must also be clean and totally free of impurities, N46 hydraulic oil is encouraged .
4. Oil transforming is needed following the preliminary a hundred operation hours,afterwards as soon as every single 3000 hrs.
5. The energy unit ought to be mounted horizontally.